Why do houses flood here that are nowhere near a river?
Because the rain that causes it falls faster than the ground and the drains can take it. On October 7, 1949 more than six inches fell on Greenville in a few hours, which is the pattern that puts water into a house on high ground as readily as into one beside the water.
River flooding and flash flooding have different causes and different timing. A river rise can be watched coming. A cloudburst over your own block gives no warning at all: the water takes the shortest route downhill, and if your house sits across that route it goes in. Most of the flash flood work in Greenville is this second kind, on lots whose grading nobody questioned until the day it rained hard.
The shape of the Upstate helps the water along. Ground that slopes toward the Reedy and the Saluda moves runoff steadily rather than holding it, so the water reaches a low threshold fast and leaves just as fast, which is why people underrate it afterward. The yard dries in an afternoon and the wall cavity stays wet for a two weeks.
What should you do in the first hour?
Deal with power first, then with records, then with belongings. Keep out of standing water until the circuits to those rooms are off, photograph the depth before anything moves, and lift what you can off the wet floor. Leave the pumping and the opening up to a crew.
The photographs are worth more than they seem. A shot of the water against a door frame, a wide shot of each affected room and a close shot of any damaged item form the record that an insurer and a crew both work from. Note the time the rain started and the time you first saw water inside, because those two times explain a great deal about how far it traveled.
After that, the useful work is small. Get rugs, boxes and electronics up onto something dry. Open interior doors so air can move. What is not useful is a household vacuum on standing water, or a box fan aimed at a wet wall before the water underneath has been pumped out, which mostly moves damp air into dry rooms.
- Switch off power to the wet rooms at the panel, but only if the panel is dry and you can reach it safely
- Photograph the water line against a wall or a door frame before it drops
- Lift rugs, cardboard and electronics clear of the wet floor
- Do not run a household vacuum or a shop vacuum rated for dust on flood water
- Write down when the rain started and when water first came inside
How is flood runoff treated differently from a clean water leak?
A supply line leak puts clean water into the building and much of what it touches can be dried and kept. Flood runoff has crossed ground and pavement, so porous materials that soaked it up are usually removed rather than dried, and the surfaces underneath are cleaned before any drying begins.
The difference is not fussiness, it is what the materials can be returned to. Carpet pad, fiberglass insulation and the paper on drywall act like a sponge with a filter in it: the water can be dried out of them and the soil it carried stays behind. Nobody can clean the inside of a pad in place, so the pad comes out and the carpet above it is judged separately.
The same logic decides how high a wall is opened. If the runoff stood at two inches, the cavity above that line may be dry and stay closed. If it stood at a foot and sat overnight, the wick line is higher than the tide mark and the cut follows the readings. That is the reason a crew measures before it cuts anything.
What happens to floors after flood water?
It depends on the build-up. Tile and sealed concrete usually survive. Carpet keeps its pad and loses it; sheet vinyl traps water underneath; laminate and engineered boards swell at the joints and rarely recover. Solid hardwood is sometimes saved with mats that pull moisture through the boards.
The floor is the slowest part of the building to dry because it is the part with the most layers. Water under sheet vinyl or under a glued laminate cannot evaporate upward at all, so the covering is lifted to get at the subfloor, even where the surface looks acceptable. A subfloor left wet under an intact floor is where a long argument about a smell usually begins.
Hardwood is the judgment call. If the water was shallow and the extraction was quick, drying mats laid over the boards can draw the moisture out and the floor flattens as it dries. If the boards have cupped hard, lifted at the ends or sat in dirty water for days, the honest answer is that drying will not bring them back and the readings will say so.
- Tile and sealed concrete: usually cleaned and dried in place
- Carpet: pad out, carpet judged on how dirty the water was
- Sheet vinyl and glued laminate: lifted to reach the subfloor
- Solid hardwood: drying mats tried where the water was shallow and extracted fast