What severe storm surveys in this county actually describe
Two rated events give the shape of it. The National Weather Service office in Greenville-Spartanburg surveyed an EF1 near Simpsonville in April 2019, where a roof deck was lifted and roofing and insulation were lost, and an EF2 in April 2020 with a preliminary peak wind of 115 mph along a path of about 5.5 miles.
The detail that matters to an owner is not the rating but the damage description: a roof deck lifted, roofing and insulation gone. That is a building open across an area, and the water damage that follows is a function of how long it stays open and how much rain arrives in that time, rather than of the wind speed itself.
A path of a few miles also explains why these jobs come in clusters. Everything along that line is damaged in the same few minutes and calls in the same evening, which is why no arrival time is ever promised. The crews work in the order of what is still letting water in.
Why distributed wind damage is harder to find than a hole
Because each entry point is small and the wetting is shallow and wide. There is no dramatic stain to follow, so the wet insulation and the damp top plates have to be mapped across the whole roof area. Missing part of the zone leaves damp material above a ceiling that was just repainted.
The failure people describe afterward is always the same: a leak was patched, the ceiling was redecorated, and three rooms away a stain appeared a month later. That second stain was almost always wet on the day of the storm and was never read. One sweep of the full attic area at the start avoids the whole sequence.
The sweep is also what keeps the demolition honest. Knowing the boundary of the wet zone means ceiling board and insulation are removed to that boundary and no further. Without the map, a crew is guessing in both directions, and guessing wide and guessing short are both expensive.
- Read every slope of the attic, not only the stained bay
- Check wall top plates under affected soffits and gables
- Map the wet zone before deciding what to open
- Record the boundary, so the repair is scoped once
How an attic gets wet with the roof still apparently on
Severe wind drives rain sideways and changes the air pressure in the roof space, which pulls water in through soffit vents, ridge vents, gable louvers and gaps under flashing. Nothing is missing when you look from the ground, and the insulation is wet in bands following the air path.
This is the version that gets argued about, because from the street the roof looks untouched. The evidence is inside: damp bands in the insulation that follow the vents rather than the rafters, water marks on the inside of a gable end, and a wet top plate on the windward wall. A camera and a meter show it; a visual inspection does not.
It is also the version most likely to be assumed as ordinary condensation. The distinguishing features are timing, which lines up with one storm, and pattern, which follows the openings on the wind side rather than the coldest surfaces. Both are recorded on the first visit for exactly that reason.
Working a whole street of damaged roofs at once
Covering and water removal are done across every property first, because they are the steps where delay costs material. Drying equipment is then moved through the street as it frees up. The phone is answered at any hour and a crew is dispatched as soon as one is available.
A rated storm with a path several miles long damages many buildings in the same minutes. That reality is why these pages decline to give an arrival window: it would be a number invented for the reader's comfort. What can be promised is the order of operations and that each property is documented before anything is changed.
Owners can shorten their own job in the wait. Containers under drips, belongings lifted off wet carpet, interior doors left open and a written note of when the wind hit and when water appeared are all worth doing, and none of them require going anywhere near the roof.