Phones answered 24/7Greenville, SC
Call (833) 490-5225
(833) 490-5225
Urgent? Phones answered 24/7

Sewage backup cleanup in Greenville and Greenville County

Contaminated water is contained first, then everything porous it touched is removed, the hard surfaces cleaned, and only then is the structure dried.

  • Answered 24/7
  • Storm and river flooding
  • Wet ceilings and burst pipes

Get a fast quote

Fastest: call (833) 490-5225. Or send this and we call you back.

Sewage Backups

Sewage Backup Cleanup: what it covers

Quick answer

A backup is handled as grossly contaminated from the first minute. Greenville Water Damage Restoration answers these calls at any hour across Greenville County and sends a crew as soon as one is available, to contain the area, remove the porous material, clean and treat the structure and then dry it under readings.

Sewage Backup Cleanup illustration for Greenville, SC

A sewage backup is the one water loss where almost nothing is negotiable. The water is contaminated, so the method is set by that fact rather than by how much of it there was: contain, remove everything porous that it touched, clean the hard surfaces properly, treat, and only then dry. A teaspoon of it in a carpet is treated the same way as an inch of it on a floor.

That order is also the opposite of a clean water job. With a burst pipe the priority is to extract fast and dry faster, keeping as much material as possible. With a backup the priority is containment and removal, because drying contaminated material in place simply dries the contamination into it and moves the smell around the building.

The other difference is what happens to the air. A backup in one room affects the whole building if nothing stops it, so the working area is isolated and put under containment before any material is disturbed. That containment is not theater; it is the reason the rest of the house does not need doing afterward.

Service area
Greenville & Greenville County
Availability
Phones answered 24/7, emergencies first

Why heavy rain and sewers interact here

A long, intense downpour puts more water into a drainage system than it was built to carry, and the surplus leaves at the lowest available point. In a county that sheds rain quickly into its rivers, the load arrives fast rather than gradually, and the backups come in clusters during the same storm.

That is why a backup can happen in a building with perfectly sound private drainage. Nothing on the property is blocked; the system it discharges into is simply full. The distinguishing evidence is usually that neighbors on the same line are having the same problem in the same hour, which is worth asking about before anyone sends a camera down your lateral.

It also means the risk is highest in exactly the storms that are already causing other problems. A property that is dealing with surface water at a doorway may be dealing with a backup at its lowest drain at the same time, and the two are kept apart on site because the methods are so different.

The river downstream remembers the sewage it was given

The Reedy below the city was heavily fouled in the mill era. The lake behind the old dam at Conestee, built around 1892, filled to roughly ninety percent with sediment from mill and sewage discharge upstream, enough to make it a federal cleanup concern before the site became the 400-acre Conestee Nature Preserve, which opened in 2006.

That history is not a criticism of anybody's current system; it is a reminder of what untreated discharge actually does, and of how long the consequences last. A century of it is still sitting in sediment behind a dam south of the city. It is a useful thing to have in mind when somebody suggests hosing a backup out of a crawl space and into a yard.

The practical point for an owner is narrower. Contaminated water does not become clean by being spread out, pushed outside or dried. It has to be contained, removed and disposed of properly, and the materials that absorbed it go with it.

Why everything porous has to go

Because porous material cannot be cleaned through. Carpet pad, insulation, particle board and the paper on drywall absorb the water and hold what was in it after the moisture has gone. Drying them leaves the contamination in place with a dry surface over it, which is the worst of both outcomes.

Hard, non-porous surfaces are different. A slab, a tiled floor, masonry and solid framing can be cleaned properly, treated and kept, because the contamination sits on them rather than in them. The line between the two categories is what decides the removals, and a crew will walk it with you item by item rather than announcing a strip-out.

This page will not make any health claim, and it does not need to. The reason for the method is that the material cannot be returned to a clean condition, which is a matter of what the material is, and it holds regardless of what anybody believes about the risk.

  • Removed: carpet and pad, insulation, particle board, affected drywall, absorbent contents
  • Cleaned and kept: slab, tile, masonry, solid framing, sealed hard surfaces
  • Judged individually: hardwood, cabinetry, sealed concrete with a finish on it
  • Nothing porous is dried in place and left

What owners should not do while waiting

Do not use any plumbing in the building, do not try to clear it with a hose or a household vacuum, and do not run fans in the affected room. Each of those spreads the contamination or adds to the volume, and the fans in particular move it into rooms that were clean.

The instinct to start cleaning is strong and it is the wrong instinct here. A mop takes contaminated water across a clean floor and into a bucket that then travels through the house. A fan aerosolizes what is on the floor and distributes it. Both turn a contained problem into a building-wide one, which is the one outcome containment is designed to prevent.

What does help is keeping people and pets out, closing the door to the affected room, and photographing it from the doorway. If the backup is in a crawl space, stay out of the space entirely and describe what you can smell and see from the hatch.

Warning signs

Signs you need sewage backup cleanup

Keep everyone and all pets out of the affected area, and stop using every drain and fixture in the building until the cause is known. Do not touch the water, and wash thoroughly if you have. Keep out of a crawl space that has taken a backup. Switch off power to the affected rooms at the panel if it is dry and reachable, and do not run fans in there. Call (833) 490-5225 and describe it from a safe distance.

  • Water coming up at a floor drain, a shower base or the lowest fixture in the building
  • More than one fixture draining slowly or gurgling at the same time
  • A strong sewer smell indoors with no visible water yet
  • Water in a crawl space with a sewer smell to it rather than an earthy one
  • A toilet that rises instead of flushing, or empties when another fixture is used
  • Dark staining and solids at the edges of where the water spread
Our process

How our sewage backup cleanup visit works

  1. Keep everybody out and stop using the plumbing

    Nothing should go down any drain in the building until the cause is known, because the next load has to go somewhere. A technician will tell you which rooms to close off and to keep children and pets away. No one should be clearing it up before a crew arrives.

  2. Contain the area before anything is disturbed

    Barriers go up and the working area is put under controlled airflow so that moving wet material does not take the problem into the rest of the building. Crews work in protective equipment, and the route in and out is set up to keep traffic off clean floors.

  3. Remove the water and everything porous it reached

    Extraction first, then the removals: carpet and pad, affected drywall and insulation, particle board, and anything absorbent that was in contact. These are bagged inside the containment and carried out, with photographs taken of each item and area beforehand.

  4. Clean and treat the hard structure

    Framing, slab, masonry and any remaining hard surfaces are cleaned rather than rinsed, with the residue removed rather than spread. Treatment follows cleaning, because a treatment applied over soil does very little. This is the stage that determines whether the smell comes back.

  5. Dry under readings, then release the containment

    With the contaminated material gone and the structure clean, drying equipment goes in and the readings are logged on each visit. The containment stays until the drying is complete and the area is ready to be rebuilt, and the log is left with you.

Options

Types and options for sewage backup cleanup

A blocked private drain or lateral

The most common case: a blockage between the building and the public sewer, often roots, grease or a collapsed section. The building backs up at its lowest fixture, so a ground-floor shower or a basement drain gets it first. Clearing the blockage is a drain contractor's task and runs alongside the cleanup.

A system overloaded by heavy rain

In a prolonged downpour the sewer system takes more water than it was designed for, and the excess finds the lowest connected opening. Several properties in the same street can back up in the same hour, which is the pattern that distinguishes this from a private blockage.

A backup into a crawl space

Where the discharge happens below the floor, there may be nothing to see indoors at all. The smell arrives first and the contamination sits on the ground and in the insulation. The space has to be cleared, cleaned and dried, and the ground covering replaced rather than cleaned in place.

A commercial kitchen or multi-tenant building

Grease-related blockages and shared drainage make these more complicated, because the source and the damage may be in different tenancies. The containment has to allow the rest of the building to keep operating, and the documentation has to be clear enough to tell the two parties apart.

Job stories

Typical jobs for sewage backup cleanup

Typical job
Illustration: Typical: a drain backing up during a heavy rain

Typical: a drain backing up during a heavy rain

What homeowners notice
During a long downpour a floor drain and a low shower have backed up into a finished lower room, leaving contaminated water across tile and the base of two stud walls.
What we do
The area is closed off from the rest of the house, the water is extracted, and porous material it touched is removed rather than dried, including the lower drywall and any pad or insulation. Hard surfaces are cleaned and disinfected, and drying follows once the cleaning is complete.
What to expect
The household receives the water category with the reasoning behind it, a removal list, photographs from before the clean-up began and readings showing the remaining structure reached target.

cleaning before any drying typical visit

Skip the guesswork. Call for a straight answer.

Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what sewage backup cleanup should cost.

Greenville County

Why sewage backup cleanup is different in the Upstate

A great deal of the housing across the service area sits over a crawl space rather than a basement, which changes where a backup ends up. The discharge goes under the floor, onto the ground and into the insulation, with the smell reaching the rooms above before anything is visible. That version takes a full clear-out of the space and a new ground covering, and it overlaps with the crawl space page.

In a storm heavy enough to load the drainage, the same building is often taking water from outside as well. Where that has happened, the two are documented separately even though one crew does both: surface flooding is handled on the flash flood page, and the backup is handled here, under containment.

Conestee, south of the city on the Reedy, carries the clearest local record of what untreated discharge does over time, and the preserve there is now the reason that stretch of river is better known for its trails than its sediment.

Related

Crawl Space Water Damage

A wet crawl space is a humidity source directly beneath the floor. Pumping is the start; the job finishes when the framing above reads dry.

Flash Flood Water Damage

Runoff that came in fast is pumped out, the soaked part of the structure is found with meters, and the building is dried under readings rather than by guesswork.

Mold After Water Damage

Growth is a symptom of material that stayed wet. It is contained and removed, and the moisture that allowed it is dried out, in that order.

FAQ

Sewage Backup Cleanup FAQs

It was only a small amount. Does it really need all this?

The method is set by what the water is, not how much of it there was. A small volume in a carpet still contaminates the pad and the subfloor, and those cannot be cleaned through. The scale of the work changes with the area affected; the approach does not.

Can the carpet be cleaned instead of thrown out?

The pad cannot, and it goes without exception. A carpet that was in contact with contaminated water is judged on its own, and the usual honest answer is that it goes too. Nobody can clean the inside of a pad in place, and leaving it is what produces the smell that will not shift.

Who clears the blockage?

A drain contractor or the water utility, depending on where it is. That work runs alongside the cleanup rather than before it, because nothing can safely be used in the building until the cause is dealt with and the contaminated material is out.

How long does a backup job take?

The removals and cleaning are usually quicker than people expect, and the drying that follows takes as long as any other drying job of the same size. The containment stays up until the drying is finished, so the room is out of use for the whole period rather than just the first day.

Will the smell go?

It goes when the contaminated material is out and the hard structure has been cleaned and treated properly. A smell that persists after a cleanup almost always means something porous was left in place or a crawl space below was not dealt with.

Is a backup covered by insurance?

Sewer and drain backup is often a separate item on a policy rather than part of the standard water cover, so it is worth checking what yours includes. Only your insurer can tell you. Keep the photographs, the list of removals and the moisture log either way.

Can I prevent it happening again?

Sometimes, depending on the cause. A private blockage can be cleared and the line inspected; roots and grease have straightforward remedies. Where the cause is a system loaded by heavy rain, the available measures sit on the plumbing side and are worth discussing with a drain contractor.

WhatsApp